HOME >> INDUSTRY NEWS >> Colorful stone coated steel roof tiles and color steel tile difference

Colorful stone coated steel roof tiles and color steel tile difference

 Published:2017-8-12 4:29:10    Source:    Views:75

 Colorful stone coated steel roof tiles and color steel tile difference

 
 
Use Uses:
 
1, color steel tile for temporary board room, small factories, site fence and other temporary places;
 
2, colored stone coated  metal roof tiles are for villas, high-rise buildings and other permanent residential buildings.
 
Color stone metal tile manufacturers today to tell you about Pingwa roof construction requirements, to ensure the construction quality will be strictly in accordance with the construction requirements. We also know the quality of construction on the use of colored stone tile the importance of the following let us to look at it.
(1) roof, cornice tile: tile order from the cornice from bottom to top, from left to right direction. Corn tiles to pick out the cornice 50mm; approach roof tile material includes two models: earth red K64, canyon red K84 (slotted), paving way by the earth red K64: Canyon red K84 (slotted) 2: 1 The proportion of paving, Canyon K84 slotted with two pieces of earth red K64 splicing gap corresponding, was a straight line, the overall paving effect is the canyon red K84 (slotted) was oblique bar, and the earth red K64 cross arrangement The
(2) oblique ridges, oblique trench: the first tile (or select the available defective tile) hanging, the ditch side requirements cover the water width of not less than 150mm, pop the ink line, compiled number, the excess tile surface Cut off (the best use of steel saw off, to ensure that the edge of the straight), and then by the order of numbers hanging; inclined roof of the flat tile is also linked by the above method to ensure that the ridge tile flat tile on each side is not less than 50mm.
(3) Ridge tile: hanging flat ridge, diagonal ridge tile, it should be tattoo twisted, paved straight. Buckle tile with 1: 2.5 lime mortar paved flat, ridge tile interface and the gap between the tile and flat tile, the use of anti-cracked fiber mortar masking flat, ridge tile and flat tile on each side Not less than 50mm; flat ridge joints to the main wind direction; diagonal joint mouth down (and from the bottom up laying), flat and ridges at the junction of the use of knife dust gray seal. Paved flat ridges and ridges straight, no ups and downs.
stone coated steel roofing sheets
RELATED NEWS